REBLT JOHNSON SHIP-MASTER EVINRUDE 2 HANDLE OUTBOARD CONTROL BOX W/ 15' CABLES

Description

DESCRIPTION:
Johnson (Evinrude and Gale) Dual (2) Lever Ship-Master Remote Control Box
Identical to Evinrude Simplex and Gale Bosun remote control boxes
P/N: 378390 and 278434 (replaced by 381371 in 1966).
This is a super condition, excellent working reconditioned control box.
Complete with standard pre-1979 (fits 1953 and up) Type 400 throttle and shift cables and connector ends.
Shift cable (near side of outboard) and throttle cable (far side of outboard) are 15' long.
Box is multi-directional - can easily be converted from starboard to port surface mounting.
Light-duty aftermarket plastic replacement boxes without cables or ends are retailing for 9.95 and are nowhere comparable to the original rugged cast aluminum OMC box sold here.
At most marine stores new cables retail for .49 each, and cable connector ends retail for .99.
Includes port and starboard cable clamps & fasteners for attaching cables to outboard
Includes 8-page Remote Control Installation and Operating
Instructions
.
APPLICATION:
Johnson/Evinrude/Gale Outboards --- pre-1979 manual shift, NOT electric shift
Box comes rigged with two Type 400 (Uflex/OMC Long-Life/Seastar Teleflex) control cables (standard cables that will work for 1953 thru 1978 Evin/John/Gale)
Also rigged with throttle and shift cable connector guide ends
CONDITION:
Reconditioned boat repower take-out box
Brand new U-Flex throttle cable
Very nice shift cable - no kinks, no bends
Note: shift cable has 1/2" of protective tape over small vinyl split - see pic.#11)
Matched connector ends.
Nothing to hide - look at the 12 pictures,
including the inside
!
From a fresh water lake so NO damaging salt water corrosion.
Inside is super clean -
no sand, no old caked on grease, no rodent or insect debris
Newly reconditioned mechanicals - no missing parts, no broken parts, no parts needing repair.
Completely disassembled, cleaned, inspected, lubed, and reassembled
Refinished to match Johnson factory gray
One new and one exc. cond. used cable enable levers to operate freely and smoothly.
Everything is here - just hook up cables to your outboard and fasten box to your boat.
CABLE MEASUREMENT:
15' factory cable measurements are taken from the brass tube end to brass tube end.
If you are measuring just the length of the black vinyl jacket, the 15' cables would have 13 foot 10- 1/2 inches of vinyl.
RETURNS:
Please look at the pictures carefully.
Check your cable length, cable ends, and application.
If you have any questions, please ask them prior to bidding.
Sorry, factory warranty expired 50 years ago, I will not be responsible for mis-ordered parts and no returns will be accepted.
SHIPPING:
You will only be charged postage for a  19" X 18" X 7"  9 lb. carton, no additional "handling" fees will be added.